My Hot Water Tank Will Not Stay Lit

If your pilot light won t stay lit this can be for a few different reasons.

My hot water tank will not stay lit. If your pilot light won t stay lit the thermocouple is very likely the culprit. Of course if you want to make sure the job is done right with the least amount of risk contact experienced professionals at hot point for furnace repairs asap. Top and bottom of the vent seems clear and no issues with the furnace that is tied in three feet away with. If there is no gas or gas pressure is too high or low check with your utility company to see if there is any work on the system.

The control valve is the box located by the access cover. Turn the control valve to on. Replaced the hot water tank and it worked for a day and went out again. Relight the pilot light.

When the gas burner comes on use a 50 50 dish soap water mix to test the screw joints for air bubbles that indicate leaks. The gas for the pilot assembly is supplied by the main gas valve and is monitored by the thermocouple. Although a blocked gas line is one reason why the pilot light on a rheem water heater won t light or stay lit there are other reasons as well some easier to correct than others. Test for gas leaks.

You must have the pilot lit and the burner on to test for leaks so that gas is flowing through the large tube. Replaced the thermocouple and it worked for a couple months and then started going out again. The thermocouple the gas pressure or the light itself. The pilot light will not remain lit.

If your gas water heater doesn t stay lit you may have a defective thermocouple. Reopen the shutoff valve. Remove the pilot light access cover. Most gas fired water heaters use a standing pilot to ignite the main burner.

The thermocouple is a heat sensing probe that is part of the pilot assembly and. A pilot light in a hot water tank is what allows your water tank to heat up. If the smell does not dissipate replace the heater s control valve before proceeding. If the link overheats you must clean vents an.

So i had a hot water tank that would not stay lit for more than a month. Troubleshooting these problems with a water heater s pilot light can be done at home. It is located near the bottom of the tank. A faulty thermocouple or malfunction of the gas valve could be the culprit but the problem may be as simple as a draft coming from a crack in the wall or under the door.